Use code at checkout for 10% off all oil-based sculpting clays Shop clays →

Silicone mould calculator

Work out how much silicone rubber you need for a pour-on or brush-on mould, how much plaster or fibreglass to use for the support jacket, and how to split a mix into Part A and Part B. We will suggest the right RPM products and kit sizes to buy.

Units

1. Your mould box

Measure the inside of the box or frame you will pour into, up to the height you will fill it.

Box shape

2. Your model

The model takes up space, so it is taken away from the box. Pick the shape it is closest to.

Model shape

Leave at least 1cm (½in) of silicone around and above the model so the mould holds its shape.

1. Your model's surface

We work out the area to be covered. The base the model sits on is left out. These are the same measurements as the brush-on tab.

Model shape

Very detailed or undercut models have more surface than a plain shape. Add 10–20% to your sizes if yours is very textured.

2. Silicone

Most brush-on moulds are 3–6mm thick, built up in 3 or 4 coats. Brush the first coat thin to pick up detail, then thicken the rest with Thixotropic Paste so they stay put on upright surfaces.

2. Jacket material

Material

A plaster jacket is usually 15–25mm thick. Lay jute scrim between coats of plaster to stop it cracking.

3. Silicone

Split a mix into Part A and Part B

Enter how much mixed rubber you want and we will tell you how much of each part to weigh out.

Always weigh both parts on digital scales, not by eye or by volume. Mix well, scraping the sides and bottom of the pot.

You will need about

0.00 kg

Enter your measurements to see what to buy.

These are estimates for planning. Always check the product label and data sheet, and test on something small first. Not sure? Call us on (01) 456 4277.